
玻璃盘360度牙伤光学筛选机
Optical screening machine for teeth injury of glass plate in 360 degrees
HL-05-360-LSLM
参数规格
Specifications
本机台外观尺寸:
约2300mm*1200mm*2300mm(长*宽*高)
机台重量:约750KG
更换规格:约10分钟
检测范围:
长度:10-60MM 直径:5-25mm (可以倒立)
速度最快可达600支/分钟
本机台为检测螺栓、螺帽一体机
最多可装8支CCD
电源:交流单项220V 50HZ
功率:约3KW
The appearance size of this machine:
About 1200mm*1200mm*2300mm (length*width*height)
Machine weight: about 750KG
Replacement specification: about 10 min
examination range:
Length: 10-60mm Diameter: 5-25mm (can be inverted)
The fastest speed:600 / min
This machine is a testing bolt and nut integrated machine
Up to 8 CCDs
Power: AC single 220V 50HZ
Power: about 3KW
可检测项目
Suitable for
○外螺纹360度牙伤检测;○螺纹直径公差检测;
○最大/最小对边公差检测;○有无印记检测;
○螺纹牙底径检测;○最大/最小对角公差检测;
○螺纹牙中径检测;○内孔与外圆同心度检测;○牙距检测;
○内孔径有无毛刺检测;○有无螺纹检测;
○头部有无电镀检测;○斜牙检测;○头部表面开裂;
○粗细牙检测;○内孔直径公差;○尖锐度检测;
○有无焊点,及焊点数检测;○头部真圆度测量;
○焊点面积检测;○搓牙有无到位检测;○牙数检测;
○螺帽牙内有无铁屑检测;○各部位台阶公差检测;
○梅花形状及有无滚花检测;○头部厚度公差检测;
○螺帽烂牙、坏牙检测(可360度检测);○总长度公差检测;
○Thread diameter tolerance detection;○Maximum / minimum alignment tolerance detection;○Threaded teeth bottom diameter detection; ○Maximum/minimum diagonal tolerance detection;○Thread middle diameter detection; ○Concentricity detection of inner hole and outer circle; Distance detection between teeth;
○Detection for burr in internal aperture or not; ○Thread or not;
○Electroplating on head or not;○ Oblique teeth detection; Head surface cracking;
○Teeth thickness detection;○ Diameter tolerance of inner hole;○ Sharpness detection;○Detection for solder joint or not and the number;○Head roundness measurement;○Solder joint area detection;○Detection for rub teeth in place or not;○Teeth number detection;○Detection for iron chip in nut teeth or not;○ Step tolerance detection of each part;○Detection of plum blossoms and annular knurl or not; ○Head thickness tolerance detection;○Detection for broken teeth and bad teeth of nut (360 degree detection);○Total length tolerance detection;